What does of6 mean on Cabrio washer?

What does of6 mean on Cabrio washer?

drive motor tachometer error
The “F06” fault code indicates a drive motor tachometer error. This means the control is unable to properly detect motor speed and the machine will shut down. If the failure occurs during high-speed spin, the door will unlock after 3 minutes.

What does error code F54 mean?

Was washing yesterday and the machine stopped working in the Rinse cycle, showing error code “F54”. The F54 error code flashes when the machine/motor control board detects high current for the motor module.

How do I fix the code on my Cabrio washer?

DIY Repair

  1. Unplug the washing machine for 2 minutes and then plug it back (it will help the appliance re-conduct self-diagnostics and conclude that there is no breakdown);
  2. Press the START and PAUSE buttons simultaneously and hold them for 1 minute to clear the error code.

How do I fix SD error on Whirlpool Cabrio?

Simply put, too much detergent was used and an excessive amount of suds or foam was produced. Adding an additional rinse cycle without adding any more detergent might fix this problem. Sometimes the machine will automatically detects this problem and add a pause and additional rinse cycle in order to break up the suds.

How long do Whirlpool Cabrio washers last?

Top loaders typically have a longer life than front load washing machines. This model should last about 14 years.

How do you reset a Whirlpool Cabrio?

Press the Start Stop button once. Rotate the dial until Rinse, Wash, and Stop light illuminate. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.

How do you clear the code on a Whirlpool Cabrio?

Try the Cabrio Reset Procedure Touch any button that you see on your display pad. This will clear the error code. Or you can press PAUSE/CANCEL. Choose a cycle and press START.

What does E3 and F5 mean on a Cabrio washer?

The F5 E3 alert indicates there is issue with the lid lock. Do not force the lid open, as permanent damage could occur.

How do you troubleshoot a Cabrio washing machine?

Clean all contact areas on the lid and the washer. Try unplugging the washer to allow the control panel to reset. Plug the washer back in and see if the problem resolves. If the door sounds like it is engaging, but doesn’t, it is time to run a diagnostic test.

How do you reset the code on a Whirlpool Cabrio?