Can you use table saw like a jointer?

Can you use table saw like a jointer?

Using Your Table Saw as a Jointer. Even if you own a jointer, you’ll want to master this technique. With the addition of a simple shop-made fence, you can easily edge joint on your table saw. Remember that man-made materials like plywood can be hard on steel jointer knives – but not on carbide table saw blades.

Why do you need a jig to joint on a table saw?

Quite simply, there are more versatile tools that are your first priority when putting together a woodworking shop. Build a simple table saw jointer jig that will give you the clean, straight edges necessary to do glue-ups and make other tight-fitting joints.

How much should a jointer take off?

Again, the maximum cut will depend on the width and density of the workpiece, but I generally don’t remove more than about 1⁄8″ at a time. For pieces that aren’t much longer than your infeed table, hook your heeled pushblock onto the trailing end of the board.

Can a router be used as a jointer?

Is it possible to use a router table as a jointer? John Brock: Yes, a very narrow jointer, good for edge joining but too narrow for face jointing. Make sure your infeed and outfeed guides are long enough and rigid enough, then you can set it up like a jointer layed on its side.

How does a jointer work on a table saw?

Using your finger, align the fence and jig so that the outside face of the blade is perfectly even with the edge of the fence. When that’s done, lock the fence in place, turn on the machine, and push the jointer jig into the blade. Stop until you’ve reached the pencil mark you left earlier.

Where to place a jointer jig on a shop table?

On your shop table, position the upper board on the plywood base, centering it on the long axis (about 6 inches in from each end) and 2 1/2 inches in from the right edge of the plywood base. Using your pencil, make a mark through the left end of the slots onto the plywood below.

What can I use as a jointer knife?

Remember that man-made materials like plywood can be hard on steel jointer knives – but not on carbide table saw blades. Let’s get cutting … Melamine works great for the fence, but anything will do the job.

What kind of tool do you use to joint wood?

Many projects are dependent on wooden boards being perfectly straight without any cups or twists. When dealing with warped boards, the go-to tool would be a jointer. These tools produce perfectly flat faces and edges with only a couple of passes over the cutterhead.