# What ohm resistor do I need for LED?

## What ohm resistor do I need for LED?

LEDs typically require 10 to 20mA, the datasheet for the LED will detail this along with the forward voltage drop. For example an ultra bright blue LED with a 9V battery has a forward voltage of 3.2V and typical current of 20mA. So the resistor needs to be 290 ohms or as close as is available.

Why do you need a 330 ohm resistor for an LED?

Detail: 330 ohms may be used by some people as a “get you going” value that works “well enough” in many cases. The purpose of the resistor is to “drop” voltage that is not required to operate the LED, when the LED is operating at the desired current.

### What resistor do I need for LED 12V?

860 ohms
Determine the voltage and current needed for your LED. We’ll use the following formula to determine the resistor value: Resistor = (Battery Voltage – LED voltage) / desired LED current. For a typical white LED that requires 10mA, powered by 12V the values are: (12-3.4)/. 010=860 ohms.

Do 12v LEDs need resistors?

LEDs can be ran off multiple voltages, but a series resistor is required to limit the current in the circuit. Too much current in an LED will destroy the device. As with all diodes, LED’s will only allow current to flow in the direction from the anode to the cathode.

## Do you need a resistor for every LED?

An LED (Light Emitting Diode) emits light when an electric current passes through it. The simplest circuit to power an LED is a voltage source with a resistor and an LED in series. If the voltage source is equal to the voltage drop of the LED, no resistor is required.

What does 100k resistor mean?

Actual value of 100k Ohm resistor is calculated as: 1st band= Brown= 1 (1st digit) 2nd band= Black= 0 (2nd digit) 3rd band= Yellow= 4(multiplier)= 10000. 4th band= Gold= ±5% (tolerance)

### What happens if you use an LED without a resistor?

When hooking up an LED, you are always supposed to use a current-limiting resistor to protect the LED from the full voltage. If you hook the LED up directly to the 5 volts without a resistor, the LED will be over-driven, it will be very bright for a while, and then it will burn out.