What is a pilot adjustment screw?
Carburetors control the amount of air and fuel entering the engine to provide the correct mixture for combustion. This leaves the pilot jet size and the pilot screw for the idle and low throttle conditions. …
Can you adjust the pilot light on a gas fireplace?
On some fireplaces, there will be a “Lo-Hi” button that allows you to adjust the flame upward or downward. On others, there will be a screw that you can easily adjust with a screwdriver. Turning the screw clockwise will lower the flame, while a counterclockwise motion will turn it up.
Is my pilot light too high?
A: There is a way to control the height of the pilot light flame. The pilot flame should touch the thermocouple at a specific level. If the flame is blue and weak, and barely reaches the thermocouple, it needs to be stronger. If it extends well above the thermocouple, it’s too strong.
Where is the pilot light on my gas fireplace?
The pilot light is generally located behind a panel that you can remove or at the bottom of your fireplace. Turn on the supply line to the gas fireplace. If you have an electronic setting which controls the temperature of the unit, make sure the electric switch is on.
How do you light a pilot light on a gas fireplace?
Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot tube. The pilot should start as soon as the flame is close enough. Hold the pilot button down for about 20 seconds to give the thermocouple time to heat up, then release it. The pilot should stay lit.
When should I adjust my pilot screw?
With engine running at low RPM, turn the screw in clockwise until the engine begins to stumble, then turn the screw counterclockwise until the engine stumbles, noting how many turns in/out both occurred. Now, adjust between these two settings to achieve highest RPM and smoothest running engine.
Should pilot light stay on in gas fireplace?
Leaving the gas on keeps this compound moving out of the tubes. Keeping the pilot light on will also keep moisture out of the unit and in turn, help prevent corrosion. As you can see, it’s probably best in most cases to extinguish the pilot light in your gas fireplace during the months when you don’t need heat.
Is my pilot light too high gas fireplace?
The pilot flame should touch the thermocouple at a specific level. If the flame is blue and weak, and barely reaches the thermocouple, it needs to be stronger. If it extends well above the thermocouple, it’s too strong.
Which is the remote control code for Mertik Maxitrol?
OPERATING INgTRUCTIONS 11 iii-11m; Q.“ Figure 5 Din Smlm “Rennie Mindset nan-yemww General Notes —Remote Handset The control is radio frequency operated. A code (chosen from among 4.000 available codes) is preset for all Mertik Maxitrol appliances. but can be changed il required (ts addiiionai codes available].
How to install Mertik G6R E flame remote ignition system?
MERTIK mnxrrnou Instructions for Installation and Operation 6 “‘”‘- e-FLAME Remote Electronic Ignition System CE®F© CAUTlON!
Which is the gas combination control for Maxitrol?
Gas Combination Control – Standard Gas Combination Control – Optional GV34/GV38 Receiver GV60 Receiver (Radio Frequency) GV60 Receiver (Infrared) 0° to 80°C 0° to 110°C 0° to 60°C 0° to 80°C 0° to 60°C 32° to 176°F 32° to 230°F 32° to 140°F 32° to 176°F 32° to 140°F