Should a mower deck be level?
Level the mower deck to ensure grass cutting height is even across the width of the deck. This will help ensure a smooth and seamless side-by-side blend between each row of freshly cut grass.
Should mower deck wheels touch the ground?
Mower deck gauge wheels should be properly adjusted to prevent scalping grass on uneven terrain. The bottom of the wheels should sit approximately 1/8-1/2 of an inch from the ground, depending on your cutting height.
Why does my mower mow uneven?
Uneven cutting is wavy or smooth troughs in the lawn surface….Uneven Cutting.
| CAUSE | SOLUTION |
|---|---|
| Blades are damaged | Replace the blades |
| Deck is clogged with grass clippings | Clean out the deck |
| Deck shell is damaged | Repair or replace the deck |
| Mower spindle is bent or loose | Repair or replace the spindle |
Should my mower deck be lower in the front?
For most effective results, a lawn mower deck should have a pitch of 1/8-inch to 1/2-inch between the height of the deck rear to the height of the deck front. In any case, the front of the deck needs to be pitched lower than the deck rear, but don’t pitch too much because deck pitch that’s too steep can scalp lawns.
What kind of parts does a John Deere f725 have?
While this is not an inclusive list of all the parts for a John Deere F725 Front Mower & Parts List, these are the typical parts that we see purchased for your model. Regardless of your John Deere model, these John Deere parts are used frequently in maintaining and your John Deere F725 Front Mower & Parts List and can be used around your garage.
How to level a John Deere riding mower deck?
The wheels will carry the mower deck over higher areas in the lawn to give it an even cut. Make sure the mower is parked and then mount the mower. Raise the deck into the transport position. Make sure the anti-scalp wheels are not making contact with the ground. Lower the deck to 76 mm (3 inches).
Where is the cutting height on a John Deere lawn mower?
Raise the mower and place the mower cutting height knob at the position specified for deck leveling. Lower the mower and check that the mower wheels are not making contact with the ground and raise if necessary. Place the mower gauge under the mower at the adjustment point near the left rear corner.