What is the TX power of MikroTik?
With 17dBm max output power you can not do much (I assume this is a hap lite or small AP product integrated antennas). With such a product you can lower the output power to reduce interference if you have couple of Wifi AP close buy. or you have high or low gain antenna that you want/need to match over data rates.
What is frequency mode MikroTik?
Three frequency modes are available: regulatory-domain – Limit available channels and maximum transmit power for each channel according to the value of country. manual-txpower – Same as above, but do not limit maximum transmit power. superchannel – Conformance Testing Mode. Allow all channels supported by the card.
What is Superchannel in MikroTik?
superchannel is a mode, not a frequency. Superchannel removes some restrictions and should be used ONLY in laboratory for testing. To be specific, Superchannel will allow you to use any frequency supported by your wifi chip/card, including licensed frequencies.
How can I extend my mikrotik WIFI range?
Check out the wireless testing and the full analysis of the Mikrotik NetMetal ac2.
- Access the RouterOS GUI.
- Disable any previous configuration.
- Detect the SSID of the network that you wish to repeat/extend.
- Set up the wireless repeater.
- Check out the IP address of the new wireless repeater.
What is adaptive noise immunity?
Adaptive Noise Immunity (ANI) adjusts various receiver parameters dynamically to minimize interference and noise effect on the signal quality.
What are the 2.4 GHz channels?
In the 2.4 GHz band, 1, 6, and 11 are the only non-overlapping channels. Selecting one or more of these channels is an important part of setting up your network correctly.
What are the 5GHz WIFI channels?
In the 5GHz band, we have channels ranging from 36 up to 165, and in the 6 GHz band, we have Wi-Fi channels ranging from 1-233. Both frequencies allow for channel width from 20 MHz-160 MHz).
What is WIFI DFS channel?
What is DFS channel? DFS is Dynamic Frequency Selection, which is a function of using 5 GHz Wi-Fi frequencies that are generally reserved for radar, such as military radar, satellite communication, and weather radar. The main benefit to use DFS channels is to increase the number of Wi-Fi channels.