How do you fix a jammed Stanley Hammer Tacker?
Here is the best way to do it:
- Squeeze stapling end of hammer. tacker together, taking care to. avoid sharp staple.
- Remove locking pin.
- Press end clip in, then up.
- Pull out spring assembly.
- Remove staple channel.
- Clear and reassemble.
How do you open a jammed staple gun?
Hold the top of the stapler magazine with two fingers and slowly, while maintaining firm pressure, start pulling the lid apart from the part of the magazine that holds the staple. Be careful not to do this too quickly, or the lid might again fly open, spraying the staples all over your office or desk.
How do you fix a jammed stapler?
A paper clip is the perfect size for picking at a jammed stapler. The method is the same as above, using the loop of the paperclip to try to loosen the jammed staple up so it falls out of the magazine. You can also try to pick out the jammed staple with the point of the paperclip, gliding it out.
How do I Unjam my bht150 Bostitch?
Bostitch is owned by tools-giant Stanley….Sometimes the staplers will jam, despite being called jam-free.
- Disconnect the construction stapler from the air supply. Use a hammer and punch to do this.
- Push the driver upwards and past the jammed staple.
- Tap the hammer against the punch and the jam should clear.
How do you unjam a Stanley stapler?
Use a screwdriver to push the pin out of the bottom of the stapler. The pin is on the bottom of the stapler right above the pusher mechanism you just pulled out. Push the point of the screwdriver onto the pin, then grab it and slide it out of the stapler. Slide the magazine out to remove any jams.
How do you unjam a Bostitch bht150?
Warning
- Disconnect the construction stapler from the air supply. Use a hammer and punch to do this.
- Push the driver upwards and past the jammed staple. Do this by putting the punch at the tip of the driver, which you should see coming out of the nose.
- Tap the hammer against the punch and the jam should clear.