What is the configuration of switch?

By Other

What is the configuration of switch?

Table 2-2 Configure the Switch Management Interface

Enter global configuration mode. S1# configure terminal
Configure the management interface IP address. S1(config-if)# ip address 172.17.99.11 255.255.0.0
Enable the management interface. S1(config-if)# no shutdown
Return to privileged EXEC mode. S1(config-if)# end

How can I find switch configuration?

How to configure Cisco switch?

  1. Initial command prompt “Switch>” appears on the screen.
  2. Type “enable” next to it and press “Enter”.
  3. This will take you into the “EXEC” mode, also known as the Global Configuration mode.
  4. Go into configure mode using configure terminal.
  5. Enter the configuration commands one per line.

How do you hook up a H3C switch?

Connecting the switch to the network

  1. Connect one end of a twisted pair cable to the port.
  2. Connect the other end of the twisted pair cable to the RJ-45 Ethernet port of the peer device.
  3. Check the port LEDs for incorrect connection.

What compound is H3C?

Heptane or n-heptane is the straight-chain alkane with the chemical formula H3C(CH2)5CH3 or C7H16, and is one of the main components of gasoline (petrol)….CHEBI:43098 – heptane.

ChEBI Name heptane
ChEBI ID CHEBI:43098
Definition A straight-chain alkane with seven carbon atoms. It has been found in Jeffrey pine (Pinus jeffreyi).

Do switches have an IP address?

To summarize, unmanaged and layer 2 switches do not have an IP address, whereas managed and layer 3 switches do. Having an IP address assigned to your switch provides you with a way of connecting to it remotely and perform any configuration that is needed.

What are the steps to configure a switch?

  1. Step 1: Inspect your hardware. Check the model number of your shiny new switch.
  2. Step 2: Set up management IP.
  3. Step 3: Check VTP revision number.
  4. Step 4: Configure access ports.
  5. Step 5: Configure trunk ports.
  6. Step 6: Configure access ports.
  7. Step 7: Set up VTY line config.

How do I enable telnet on my h3c switch?

To enable Telnet login, perform the following tasks: Enable the Telnet server feature. Assign an IP address to a Layer 3 interface and make sure the interface and the Telnet client can reach each other. Configure an authentication mode for VTY login users.