How do I reset my Onkyo amp?
Hold down the “VCR/DVD” button and, with another finger, press the “On/Standby” button. Watch the display. You should see “Clear” appear on the receiver’s display before it goes into standby mode.
Why does my Onkyo receiver keep turning off?
When you connect the bad wire or speaker the receiver will shut down. If after you connect them all if the receiver now stays on then there was a short where the wires were connected to the receiver that you repaired when you replaced them.
How do I update Onkyo firmware via USB?
- Connect the USB storage device to your PC.
- Download the firmware file from the Onkyo website to your PC and unzip.
- Copy all unzipped files and folders to the root folder of the USB storage device.
- Make sure to copy the unzipped files.
- Connect the USB storage device to the USB port of the unit.
How to factory reset Onkyo tx-nr515 7.2 home theater surround receiver?
How to Factory Reset Onkyo TX NR515 7.2 HDMI Home Theater Surround Audio Video AB ReceiverPress and hold CBL/SAT button, then press and hold the On/Off butto…
How long does it take to update tx-nr515?
Precautions for TX-NR515 / TX-NR515AE / HT-R791 Firmware Update 1 Please read the update instructions carefully before beginning. 2 The firmware update should take 30 to 40 minutes. 3 Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish.
What to do if your Onkyo a / V receiver is damaged?
Insert or remove a USB memory device from the A/V receiver when updating via USB; Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device. If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.
What are the latest firmware updates for Onkyo?
The latest update includes the following content: Improve Spotify Connect operation. Improve audio output of DTS-HD Master Audio with a particular Blu-ray disc. This particular firmware update is only available via USB installation.