How do you run a diagnostic test on a Bosch dishwasher?
For many Bosch dishwashers, this is done by pressing the “start” button and waiting for a response. If this doesn’t cause the cycle to resume or fix the problem, press and hold the “start” button for three to five seconds, then wait to see whether this works.
How do I troubleshoot my Bosch dishwasher?
Reset the dishwasher by pressing and holding the “Start” button for at least three seconds. Depending upon the Bosch dishwasher model you have, you also can push the “Cancel-Reset” button to reset the dishwasher. Select a new cycle and press “Start.”
How do I find the error code on my Bosch dishwasher?
Error codes for Bosch display dishwashers. Error codes are shown in alphanumeric format E on Bosch dishwashers screen; At the same time, some models display the prefix “E” instead of the “F” one.
How does the Bosch she dishwasher test program work?
The test cycle runs the dishwasher on its normal cycle, and then reports back an error code to help you identify the problem. Instructions on running the Bosch SHE dishwasher test program vary from model to model, but it’s usually accessed by a combination of holding down and pressing the existing buttons to initiate the cycle.
Where is the Diagnostic Code on my Bosch dishwasher?
While pushing (and holding) any two wash cycle buttons, turn the dishwasher on with the on/off switch. After releasing the buttons, LED “B” will be lit and LED “C” will flash, confirming you’re in the special programs menu.
How do you turn on a Bosch dishwasher?
Press and hold the Power Scrub Plus and Regular Wash buttons Turn on the dishwasher, then release the two buttons. The light above each of these buttons should flash Start the test cycle by pressing the Power Scrub Plus and Regular Wash buttons again
What is the cycle Countdown on a Bosch dishwasher?
Cycle Countdown display will show “88” when REGULAR WASH button is pressed and “8h” when Delay Start button is pressed. To start testing, press both the SCRUB WASH and DELICATE/ECONO buttons a second time. When testing has ended, Cycle Countdown display will show a fault using codes below.