How do you reset the anti theft system on a 2006 Jeep Commander?

By Life

How do you reset the anti theft system on a 2006 Jeep Commander?

To reset the 2006 jeep grand cherokee anti theft system unlock the driver’s side door with the key and then lock it, and then unlock it again and the system should be cleared.

How do you turn off the alarm on a Jeep Commander?

Unbuckle then buckle the driver-side seat belt three times within 10 seconds. End with the seat belt unbuckled. This must be done within 60 seconds of turning the ignition to “On.” Turn the ignition to “Off.” You’ll hear a chime, indicating that the alarm has been turned off.

How do I get my jeep out of security mode?

To reset the Jeep Liberty’s anti-theft system, pull on the driver’s handle and unlock the driver’s door manually with the chipped key. You can also depress the panic lever to disable the alarm. Alternatively, press the panic button for 5 seconds followed by depressing the lock command 2 times.

How do I reset my Jeep alarm?

How to Turn Reset the Alarm on a Jeep Wrangler

  1. Open the dash panel cover located underneath your dashboard (Driver Side)
  2. Turn on the Car.
  3. Press and hold the red toggle switch.
  4. Allow the alarm to turn off.
  5. Listen out for a chirping sound.
  6. The LED light will shine indicating the alarm has been successfully reset.

Are there any recalls on a 2006 Jeep Commander?

CHRYSLER IS RECALLING 24,461 MY 2006 JEEP COMMANDER VEHICLES EQUIPPED WITH 4.7L V8 ENGINES. THE POWERTRAIN CONTROL MODULE (PCM) WAS PROGRAMMED WITH SOFTWARE THAT MAY ALLOW THE ENGINE TO STALL UNDER CERTAIN OPERATING CONDITIONS. OWNERS MAY CONTACT CHRYSLER AT 1-800-853-1403.

How do I get my car out of anti theft mode without remote?

Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.

How do I get my truck out of anti-theft mode?

Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.